This is were the frame is bent. Hopefully I can fix it. Otherwise, the frame need a passengerside floorboard rail, a hole patched in the bottom passenger frame rail, and new battery brackets. But, it is better than the one currently in the car, since that one is broken in half due to rust. The plan to straighten is as follows: 1. Put a sheet of plywood against the vertical goalpost. 2. Using a bottle jack and a length of pipe, slowly attempt to push the front crossmember back into place (it is bent back about 3/4 of an inch), with the bottle jack resting on the plywood and the pipe pushing the crossmember. 3. Weld up any tears in the frame. Well, that's the plan anyhow. I'm going to try this at the end of May, so I'll let you know how it turns out. Hey, the frame was only $75, so there's not a whole lot to loose.