This
is NOT to be confused with the 2 inch Medium trench mortar of WWI. This,
unlike the Stokes and other mortars has no bi-pod for
support. It is a man packed, very light, close quarter infantry support
weapon designed to move with the fluid lines of the WWII tactics. It
could almost be described as a grenade launcher rather than a mortar. The two inch mortar was fired hand
held with the spade (base plate) firmly against the ground. The user
fired a round, then adjusted the angle for the next shot, maximum range
500 yards. The white line is
the sighting line. It was possible
for an experienced (and brave) operator to use this weapon vertically as
an anti-tank weapon, but the recoil, unless braced against a tree or
building, is horrendous.
Mortars are especially effective at
laying smoke. They are especially useful also for firing against troops
in woods or light, single canopy jungle, because of the Air Burst modifier. The mortar can also be used
to fire at concealed or suspected targets in order to reveal enemy
positions. The use of a Spotter also means the mortar can be hidden
behind a hill or other terrain feature and still fire on the enemy.
Unfortunately, the low firepower and low range of the mortar means you
cannot depend on them to break up enemy attacks in the same way as a
Stokes can by landing 10 shells per minute in a target area.
|
A
Digger holding a 2-inch mortar in its firing position. Note
the mortar bomb on the ground. Note that he is also armed with a
rifle. Note that his headgear is the standard cloth beret style
that was on issue for jungle warfare where sun protection was not
necessary and camouflage and silence while moving through thick
jungle was. |
|
The 25-pounder
gun/howitzer was widely acclaimed as the best divisional artillery
weapon to see action with any of the combatants during the Second World
War. This gun had a close connection with Canada. While it was of
British design, it provided the armament of most field regiments of the
Royal Canada n Artillery during much of the war and Canadian industry
produced many of the 25-pounder guns and much of the ammunition used by
the other armies of the Commonwealth.
The 25-pounder was the outcome of the
experience of nearly 40 years of war and peace. The lessons of the South
African War, at the turn of the century, led the British authorities to
develop the 18-pounder field gun and the 4.5-inch howitzer, both of
which gave splendid service with the Canadian and British armies in the
First World War. During the inter-war years it was decided that a new
gun should be designed which would be capable of providing both the high
angle fire of a howitzer and the flat trajectory fire of a field gun.
Theoretical studies indicated that such a gun should have a calibre in
the order of four inches and fire a shell weighing about 30 pounds. The
financial restrictions resulting from the economic depression of the
1930's made it imperative that use should be made of the existing stock
of 18-pounder guns. By relining these guns, using modem technology, it
was possible to increase their calibre to permit them to fire a heavier
shell. The original 25-pounders were thus, in reality, converted
18-pounders mounted on 18-pounder carriages.
In order to provide the ballistic
characteristics required for both the howitzer and field gun roles, the
25-pounder was originally provided with three different propellant
charges. To permit the adjustment of the charge as required to engage a
specific target, the shell and the cartridge case were loaded
separately, in contrast to the fixed ammunition of the 18-pounder gun.
Experience showed that the flexibility of the 25-pounder could be
further improved if an even greater choice of charges was provided. This
need was met by the introduction of two small propellant increments
which could be used to produce muzzle velocities between those of the
three main charges.
There was also an operational need to
increase the maximum range beyond the 11,500 yards obtainable with
Charge 3. To meet this requirement a super charge was developed to give
a range of 13,400 yards. This charge naturally produced extra stresses
on the carriage and muzzle brakes were introduced to relieve this
problem.
While the standard projectile of the
25-pounder was a high explosive Technical Details shell, numerous types
of carrier shells were developed in response to operational needs. These
included smoke, flare and star shells and even a
shell to discharge leaflets over enemy positions.
In addition to its functions as both a
howitzer and a traditional field gun, the 25-pounder had a very potent anti-tank
capability. To facilitate this function, advantage was taken of an
invention which dated back to the end of the First World War. A
circular platform was carried under the trail which could be dropped on
the ground, allowing rapid all round traverse for anti-tank firing. (See
alternate photo above)
During the course of its service life
the 25-pounder gun was mounted on numerous designs of carriage. Many of
the converted 18-pounders were lost at Dunkirk in 1940 and were replaced
with carriages designed for the 25-pounder. The two which became best
known were the Mark 4 and the Mark 5. The former had two box shaped side
brackets connected at front and rear, while the latter had a split trail
which permitted extended traverse.
Standard projectile |
HE Shell Mk. ID S/L
Fuse No. 117 or 119
Weight - 25 Ibs. |
Range Table
Muzzle Velocities |
Charge 1: 650 ft. per sec.
Charge 2: 975 ft. per sec.
Charge 3: 1,450 ft. per sec. |
Ordnance - Steel: |
Weight with breech mechanism 8
cwt. 3 qtrs (444 kgs)
Length - 96.72 inches
Calibre - 3.45 inches
Chamber capacity - 151 cu. inches
Polygroove rifling - 1 turn in 20 calibres (69 ins) |
Manufacturer |
Ordnance |
Country of Origin |
UK |
Calibre |
3.45inch (87.6mm) |
Length (metres) |
2.40 |
Wheel Base width (metres) |
1.79 |
Weight (kg) |
1,800 in action |
Ammunition |
25lb (11.33kg) shell. (HE,
Armour-piercing, Shot, Smoke, Illuminating) |
Range (metres) |
12,253 |
Rate of Fire (rounds per minute) |
10 |
|